标准资料网-标准资料免费资源平台

【英文标准名称】:Plasticsandrubbermachines-Sizereductionmachines-Part1:safetyrequirementsforbladegranulators.
【原文标准名称】:橡胶和塑料机器.尺寸削减机器.第1部分:刀片粒化器的安全要求
【标准号】:NFE63-609-1-2007
【标准状态】:现行
【国别】:法国
【发布日期】:2007-07-01
【实施或试行日期】:2007-07-20
【发布单位】:法国标准化协会(FR-AFNOR)
【起草单位】:
【标准类型】:()
【标准水平】:()
【中文主题词】:概念;压碎机;切割机;危险区域;定义;设计;粉碎机设备;粉碎机;危险排除;危害;机械工程;职业安全;塑料;塑料工业;塑料加工机械;保护措施;橡胶机器;安全;安全设计;安全装置;安全工程;安全措施;安全要求;切碎机;结构体系;用户信息;硫化橡胶;工作场所安全
【英文主题词】:Conception;Crushingmachines;Cuttingmill;Dangerzones;Definition;Definitions;Design;Disposalunits;Granulators;Hazardremoval;Hazards;Mechanicalengineering;Occupationalsafety;Plastics;Plasticsindustries;Plastics-workingmachinery;Protectivemeasures;Rubbermachines;Safety;Safetydesign;Safetydevices;Safetyengineering;Safetymeasures;Safetyofmachinery;Safetyrequirements;Shredders;Sizereductionmachines;Structuralsystems;Userinformation;Vulcanizedrubber;Workplacesafety
【摘要】:
【中国标准分类号】:G95
【国际标准分类号】:83_200
【页数】:26P;A4
【正文语种】:其他


MIL-PRF-83536B, PERFORMANCE SPECIFICATION, RELAYS, ELECTROMAGNETIC, ESTABLISHED RELIABILITY, 25 AMPERES AND BELOW, GENERAL SPECIFICATION FOR (15 APR 2003) [SUPERSEDING MIL-R-83536]., This specification covers the general requirements for electromagnetic, hermetically sealed relays for use in aircraft, missile, spacecraft, ship, and other primary vehicles or in ground support equipment (see 6.1). These relays are designed to operate over the full range from low level to power switching with contact ratings up to 25 amperes alternating current (ac) or direct current (dc). Specification sheets (see 3.1) specifying requirements for 25 ampere relays are for relays that have a maximum load rating of 25 amperes for resistive load only. All other load ratings (motor, inductive, lamp) are less than 25 amperes. The failure rate (FR) level is established at a confidence level of 90 percent for qualification and 60 percent for maintenance of qualification based on 100,000 cycles at +125?C under the rated load conditions specified herein. For application and caution information, see 6.1.